511 H2O Plus is a water base penetrating sealer designed for the protection of all surfaces. 511 H2O Plus is not a surface coating and will not alter the natural look. 511 H2O Plus does not produce a strong odor. 511 H2O Plus uses no P.F.O.S. or P.F.O.A. components.
511 H2O Plus is a water base penetrating sealer designed for the protection of all surfaces. 511 H2O Plus is not a surface coating and will not alter the natural look. 511 H2O Plus does not produce a strong odor. 511 H2O Plus uses no P.F.O.S. or P.F.O.A. components.
Read entire label and PDS/MSDS before using. This product should be used directly from container and is not under any circumstances to be thinned or diluted with anything before use.
Sealing As a Grout Release: Apply 511 H2O Plus to all surfaces prior to grouting. This step will allow quick and easy cleanup after grouting. Grout can stain many surfaces if this procedure is not used prior to the grouting process. Apply 511 H2O Plus using a Mira Brush or a clean towel. Apply enough to wet the surface. Be careful not to saturate the open grout joints. Allow 511 H2O Plus to stand for approximately 3 - 5 minutes for maximum penetration. All excess must be removed at this time by buffing surface with a clean dry towel. This is very important on polished, glazed surfaces, and porcelain surfaces. Allow 511 H2O Plus to cure for 6 - 12 hours before continuing with the grouting procedure.
After Grouting: Once grouted, make sure that all grout residue is removed from the surface with a clean sponge and water. Allow grout to dry at least 24 - 72 hours. If grout clean up is not performed effectively, an additional cleaning may be necessary to remove remaining grout residue or haze. For this procedure use Phosphoric Acid Cleaner , GCFR (Grout, Concrete & Film Remover) or Epoxy Grout Film Remover as directed.
Grout Sealing: Once the area has completely dried, proceed with the sealing of the grout for water and stain resistance. Apply 511 H2O Plus to all grout with a thin paintbrush. Any excess sealer that gets on the surface should be wiped off with a clean towel before it dries.On larger jobs, grout can be sealed by retreating the entire area including the tile or stone surface a second time. Be careful not to allow sealer to puddle or dry on presealed surfaces.
Existing Installations - Surface Preparations: Surface must be dry and free of contaminants, including previously applied sealers, dirt, lime & hard water deposits, efflorescence, rust & other heavy dirt and grime. Floor Coating/Wax Removal: To remove existing coatings and/or waxes, use Mira Strip or H2O Strip per the instructions.
Heavy Duty Cleaning: To remove lime and hard water deposits, efflorescence, rust, grease and other heavy dirt and grime use GCFR (Grout & Concrete Film Remover), Phosphoric Acid Cleaner as directed. For a non-acid deep clean use Liquid Poultice as directed.
Light Duty Cleaning: Use Mira Clean #1, Porcelain & Ceramic Tile Cleaner, Counter Kleen, or Mira Soap as directed.
Color & Gloss Enhancement: For color and gloss enhancement, use 511 Seal & Enhance, Mira Matte or Mira Shine as directed.
Existing Installations - Application Instructions: Follow the application instructions previously mentioned, except now, seal the grout and tile or stone surface at the same time. When treating surfaces together, make sure that the recessed grout is saturated with sealer.
Cure Time: 511 H2O Pluswill be dry to the touch in 1 - 3 hours and may be put into service. For optimum results the area should be kept dry and free from staining materials for 24 -72 hours.
Sign In
